#8 X 3/4" Type A Self Tapping Sheet Metal Screws | Pan Head | Phillips Drive | Steel Zinc & Bake (8000/Pkg.)

Type A Self Tapping Sheet Metal Screws are designed for rapid, reliable fastening into thin gauge metal. The pan head, Phillips drive, size #8 x 3/4 inch, and zinc plated with baked enamel finish ensure corrosion resistance and a flush, secure joint in metal assemblies.

Specs

• Dimensions: Length 3/4 inch; Nominal diameter #8
• Finish: Zinc plating with baked enamel coating
• Drive type: Phillips
• Material: Steel
• Thread type: Type A

Features

• Self-tapping design: Forms its own mating threads in sheet metal, eliminating the need for pre-drilled pilot holes in appropriate thicknesses.
• Head geometry: Pan head provides a broad load distribution and a flush surface after installation, reducing snag risk on assemblies with exterior or visible panels.
• Drive: Phillips drive enables reliable torque transfer with common hand and power drivers, minimizing cam-out during installation.
• Finish: Zinc plating with baked enamel coating delivers corrosion resistance for indoor and protected outdoor environments, extending service life in typical enclosures and panels.
• Applications: Ideal for metal enclosures, control panels, HVAC duct fittings, appliance chassis, electrical panels, and automotive trim where sheet metal fastening is required.
• Material compatibility: Steel base with zinc finish provides a balanced combination of strength and corrosion protection; suitable for general purpose metal assembly in moderate environments.